DIG DRIP IRRIGATION 25-PACK 1/2″ Drip Tubing Barb Adapter TEE (1/2″ Tee X 17mm .600 ID)

• Connects / Adapts 17mm drip tubing to 1/2″ MNPT Thread Pipe
• Special, extra sharp barb design for secure and easy installation without glue or clamps
• Fits brown PC drip line and polyethylene drip tubing with .600 ID x .700 OD
• Made of high-impact, high-strength, UV-resistant plastic for extended operation in harsh conditions
• One-piece construction

16 and 17 mm (1/2″) Barbed Fittings The brown 1/2” Barbed Drip Fittings are used in the installation of DIG’s brown PC™ drip line with 18″ spacing and with .600 ID x .700 OD drip tubing. Used by home gardeners and professional alike, the brown fittings are made of high-impact plastic, and are available in a variety of configurations. Using a double barb, two pieces of drip line or drip tubing may be pushed over the barbed sides of the fittings for a very tight fit. Features Special, extra sharp barb design for secure and easy installation without glue or clamps Fits DIG’s brown PC drip line and polyethylene drip tubing with .600 ID x .700 OD One-piece construction Made of high-impact, high-strength, UV-resistant plastic for extended operation in harsh conditions Available in a variety of configurations Products specifications Operating pressure: up to 30 PSI Color: brown Use with 1/2″ drip tubing or drip line with .550 ID to .600 ID Material: Acetal Brown 1/2″ (17 mm) Barbed Drip Fittings are available in a range of configurations for 1/2″ drip line or drip tubing with .600 ID (17 mm); they provide a simple, low cost installation method. Using the double barbed fittings, drip line or drip tubing is pushed over the barbs for a very tight fit. To use the barbed fittings with drip tubing or drip line, force the drip line or drip tubing over the barbed side of the connector, tee, or elbow.